Ok so i removed my compressor cover on my gt35r to take a look at the wheel, after i started bolting the compressor housing back on i was tightening all the bolts evenly, i tighten them all very tight one of them i accidently overtighten tooo much and stripped out the thread in the housing
. My question is its one of the six bolts holding the housing together the bolt still goes in and tightens but it was fully tighten(but unturnable by hand). Now should I get so loctite and put it on there when I reclock th turbo again when installed or a helicoil? or buy a new compressor cover? i dont mind using loctite etc as long as it doesnt leak etc. thanks
