Help!!!

[fdiaz18t]

I installed today a turbo back and the intake with ic pipes from Injen.Then a go for a slow test drive to check if everything is ok.When a hit the road between 2,500-3,000 rpms the car start to lose power and not accelarate.When I came home the check engine light turns on,I check with a scaners and a p0500 code appear(vehicle speed sensor).Then I check the service manual and localize the sensor and it seens ok with no brake cables at all.If someone has another information,will by appreciate!

[KenMasters]

Strange. Check the MAF sensor to make sure it's clipped tight. Other than that Check throttle body and intercooler inlet for dibbris. Sometimes packing popcorn finds its way into things.

[Warrtalon]

You probably have an IC pipe that came loose. It's very common when messing with IC pipes that you get a leak or one pops off completely. Check every single connection in the IC system, because you probably have a gaping hole somewhere. When there is a big hole in the IC system, you can't accelerate at all.

[ghoonk]

I second Warr's suggestion. Are you throwing a CEL? When my IC hose popped off, my car threw a CEL. If you have a CEL, finding out the trouble code might also shed some light into the nature of the problem

[Evolvd]

I agree with the previous suggestions, however the Speed Sensor code is puzzling as it has nothing to do with the motor....

[fdiaz18t]

Thank you guys!!!! It was a loose ic pipe.Im going to install the factory ones and buy an air intake only.The rubers are too small for the connections and I dont want to drive my car with a tool box in the trunk.Thanks again.

[Evolvd]

The rubers? Are you talking about the couplers? They should fit your piping just fine. However if you need/want to replace them try www.extremepsi.com or any of the other manufacturers that sell silicon couplers.