Mitsubishi Lancer Evolution Forums banner
1 - 8 of 8 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter · #1 ·
well hello over here,

it's been since july...........so i've been working on many mods. finally got my kartboy short shifter w/bushings, kartboy exhaust hangers, apexi tt, txs dtec-bc w/all the goodies, txs full ti/turboback w/racepipe. also installed devilsown.com water injection kit. i bought the 9 qt tank from a gocart distributor. need a new gravity werx 0-200 psi guage for pump pressure. dropped it, "bummer!" but ordered a new one, 2 days ago. well i did everything but the goodrich stainless brake lines. have to say, not bad!" well i'll try to post some pics later if this website lets me. well there too big......already posted on the dcevoclub website. will be installing viper 690vx monday, and maybe have a friend tint my windows. hope this helps some with ideas and answers of how hard. :p jac
 

·
Registered
Joined
·
9 Posts
Discussion Starter · #3 ·
didn't get the pics resized

but i added them to my gallery. jac
 

·
Registered
Joined
·
9 Posts
Discussion Starter · #5 ·
thanks

i hope the photo's help with install ideas. so, if anyone needs any help installing some parts i'm available for awhile. got laid off and in between jobs. jac
 

·
Registered
Joined
·
9 Posts
Discussion Starter · #8 ·
hangers

i had a rattle at idle, then a friend following me said, "every time i laid into the throttle my exhaust moved quite a bit. well this isn't to healthy for connection and welds. so i went with someone i've used on all 3 platforms. no obvious movement no, good and stiff!!!!!!!!!!!!!!!!!!!!!!!! jac :thumb:
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top