Mitsubishi Lancer Evolution Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
78 Posts
Discussion Starter · #1 ·
For some reason I feel silly for asking this, but when installing the underhood shifter bushings, do I need to use any sort of grease to help them slide in easier?

I've been searching for a while now and haven't found an answer either way.

Thanks in advance!
 

·
Registered
Joined
·
4 Posts
the shifter bushings i installed were made of brass, no grease was needed for the installation. just pop out your old ones and put in the new ones with the clips.
 

·
Registered
Joined
·
213 Posts
On a couple of cars I've done this for, ocaisionally the brass bushings don't want to slide in. This can be alleviates by taking a small peice of sand paper and cleaning out the inside of the ring of the shifter cables. I then take a little wd40 and wipe them out. Have never had an issue installing them doing it that way.
 
1 - 4 of 4 Posts
Top